VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation

Foltsvagen Golf 4
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
+ 11. Wheels and tires
+ 12. Brake system
+ 13. Body
- 14. Electric equipment and electroschemes
   14.1. Filament lamps
   14.2. Electric chains
   + 14.3. Detection of not closed chain
   14.4. Safety locks
   - 14.5. Accumulator
      14.5.1. Rules of care of the accumulator
      14.5.2. Accumulator check
      14.5.3. Battery charging
      14.5.4. Accumulator removal
      14.5.5. Accumulator installation
      14.5.6. The remarks concerning the accumulator with ventilating caps
      14.5.7. Charging system
   + 14.6. Generator
   + 14.7. Starter
   14.8. Replacement of bulbs of external lighting
   14.9. Removal and installation of an additional signal of braking
   14.10. Replacement of bulbs of internal lighting
   + 14.11. Devices of external lighting
   + 14.12. Adjustment of light of headlights
   14.13. Removal and installation of a combination of devices
   14.14. Removal and installation of switches of a steering column
   14.15. Removal and installation of switches
   14.16. Removal and radio receiver installation
   14.17. Removal and installation of high-frequency loudspeakers
   14.18. Removal and installation of low-frequency loudspeakers
   14.19. Recommendations about phone installation
   14.20. Aerial
   14.21. Check of a heater of back glass
   + 14.22. Explanations to electric circuits
   + 14.23. Schemes of electric equipment of the VW Golf car since September, 1997.

14.5.2. Accumulator check

GENERAL INFORMATION

In the accumulator it is necessary to make check of density of electrolit each 3 months to define loading ability of the accumulator.

Check is made by a plotnomer. At determination of density of electrolit it is necessary to consider accumulator temperature. At temperature of electrolit is lower 15°С on everyone 10 ° less than this temperature from the measured density subtract value 0,007. For everyone 10 ° over 15 ° add 0,007.

Electrolit density in the accumulator

Temperature	Full charging	Charging for 70 %	The discharged
Above 25 ° With	1,210-1,230	1,170-1,190	1,050-1,070
Below 25 ° With	1,270-1,290	1,230-1,250	1,110-1,130

PERFORMANCE ORDER

1. Density of electrolit measure in everyone bank. The difference in density 0,04 or more between two any banks indicates loss of electrolit or a sulfatatsiya of plates.

2. If the electrolit density between two any banks differs more than on 0,04 accumulator is subject to replacement. If the density of electrolit is lower demanded, but identical in all banks, the accumulator is necessary for charging.

3. In case of use of the unattended accumulator the condition of the accumulator can be checked only the voltmeter. In accumulators with the built-in indicator of degree of a zaryazhennost the condition of the accumulator is determined by color of the indicator. Green color of the indicator corresponds to a full battery charging. Black color of the indicator indicates need of a battery charging. Dark blue color of the indicator testifies to low level of electrolit in the accumulator.

home