VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation


Foltsvagen Golf 4
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
+ 11. Wheels and tires
+ 12. Brake system
+ 13. Body
- 14. Electric equipment and electroschemes
   14.1. Filament lamps
   14.2. Electric chains
   + 14.3. Detection of not closed chain
   14.4. Safety locks
   + 14.5. Accumulator
   + 14.6. Generator
   + 14.7. Starter
   14.8. Replacement of bulbs of external lighting
   14.9. Removal and installation of an additional signal of braking
   14.10. Replacement of bulbs of internal lighting
   + 14.11. Devices of external lighting
   + 14.12. Adjustment of light of headlights
   14.13. Removal and installation of a combination of devices
   14.14. Removal and installation of switches of a steering column
   14.15. Removal and installation of switches
   14.16. Removal and radio receiver installation
   14.17. Removal and installation of high-frequency loudspeakers
   14.18. Removal and installation of low-frequency loudspeakers
   14.19. Recommendations about phone installation
   14.20. Aerial
   14.21. Check of a heater of back glass
   + 14.22. Explanations to electric circuits
   + 14.23. Schemes of electric equipment of the VW Golf car since September, 1997.





14.13. Removal and installation of a combination of devices
GENERAL INFORMATION

Arrangement of electric sockets on a back part of a combination of devices
1–the 32-contact electric
socket of green color;
2–the 20-contact electric
socket of red color;
3–fixing device
electroconductings;
 4–a sound signaling device of pressure of oil and included light;
5–a control lamp of operation of the car with the trailer of 1,12 W;
6–32-contact electric socket of blue color
Prevention

In a combination of devices it is possible to make only replacement of control bulbs of an incandescence. At failure of one of indexes or in the presence of any other defect it is necessary to replace a combination of devices assembled.

Removal

PERFORMANCE ORDER
1. Move to the bottom situation a steering column and remove a steering wheel.
2. Release from spring clips the bottom furnish of a combination of devices (1) and remove it through the top casing (2) helmsman of a column.
3. Unscrew two screws, combinations of devices fixing the lower part.
4. Move a combination of devices forward and from a reverse side of a combination of devices disconnect electric sockets.
5. If necessary replace filament lamps.

Installation

PERFORMANCE ORDER
1. Installation is made in sequence, return to removal.
2. If the new combination of devices is established, modify indications of the Service-indicator and the counter of kilometers.