VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation


Foltsvagen Golf 4
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
+ 11. Wheels and tires
+ 12. Brake system
+ 13. Body
- 14. Electric equipment and electroschemes
   14.1. Filament lamps
   14.2. Electric chains
   + 14.3. Detection of not closed chain
   14.4. Safety locks
   + 14.5. Accumulator
   + 14.6. Generator
   + 14.7. Starter
   14.8. Replacement of bulbs of external lighting
   14.9. Removal and installation of an additional signal of braking
   14.10. Replacement of bulbs of internal lighting
   + 14.11. Devices of external lighting
   + 14.12. Adjustment of light of headlights
   14.13. Removal and installation of a combination of devices
   14.14. Removal and installation of switches of a steering column
   14.15. Removal and installation of switches
   14.16. Removal and radio receiver installation
   14.17. Removal and installation of high-frequency loudspeakers
   14.18. Removal and installation of low-frequency loudspeakers
   14.19. Recommendations about phone installation
   14.20. Aerial
   14.21. Check of a heater of back glass
   + 14.22. Explanations to electric circuits
   + 14.23. Schemes of electric equipment of the VW Golf car since September, 1997.





14.10. Replacement of bulbs of internal lighting

FORWARD PLAFOND AND FORWARD LAMPS FOR READING

PERFORMANCE ORDER
1. Remove a rasseivatel for what the flat working end of a screw-driver insert between a lamp and a rasseivatel (shooter) and carefully hook a rasseivatel.
2. Take a faulty lamp from the boss and insert a new lamp.
3. Insert a rasseivatel back, at first both small ledges into a frame, then press up and forward before fixing of both long ledges in the holder.

LATERAL LAMP FOR READING

PERFORMANCE ORDER
1. Using an edge of the thin screw-driver inserted into dredging of a rasseivatel of a lateral lamp for reading, being careful, take a lateral lamp for reading from a nest.
2. Disconnect the electric socket and remove a lateral lamp for reading.
3. From a reverse side remove a plastic cover.
4. Take a faulty lamp and insert a new lamp.
5. From a reverse side establish a plastic cover.
6. Connect the electric socket.
7. Establish a lateral lamp for reading before its accurate fixing in a nest.

BACK PLAFOND

PERFORMANCE ORDER
1. Remove a plafond assembled for what the flat working end of a screw-driver insert between a frame and an upholstery of a ceiling and carefully hook a plafond.
2. From a reverse side of a plafond shift a plastic cover aside.
3. Take a faulty lamp and insert a new lamp.
4. From a reverse side pull a plastic cover before its accurate fixing.
5. At first establish a plafond from the socket, then press it into cut in a ceiling upholstery.

LAMP OF ILLUMINATION OF THE LUGGAGE CARRIER

PERFORMANCE ORDER
1. Open a back door.
2. The plafond of illumination of a luggage compartment is located on the right side of a luggage compartment.
3. Rasfiksiruyte a plafond from the bottom party also remove it.
4. Replace a faulty lamp.
5. Insert a plafond at first from above and then from below.