VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation



Foltsvagen Golf 4
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
+ 11. Wheels and tires
+ 12. Brake system
+ 13. Body
- 14. Electric equipment and electroschemes
   14.1. Filament lamps
   14.2. Electric chains
   + 14.3. Detection of not closed chain
   14.4. Safety locks
   + 14.5. Accumulator
   + 14.6. Generator
   + 14.7. Starter
   14.8. Replacement of bulbs of external lighting
   14.9. Removal and installation of an additional signal of braking
   14.10. Replacement of bulbs of internal lighting
   + 14.11. Devices of external lighting
   + 14.12. Adjustment of light of headlights
   14.13. Removal and installation of a combination of devices
   14.14. Removal and installation of switches of a steering column
   14.15. Removal and installation of switches
   14.16. Removal and radio receiver installation
   14.17. Removal and installation of high-frequency loudspeakers
   14.18. Removal and installation of low-frequency loudspeakers
   14.19. Recommendations about phone installation
   14.20. Aerial
   14.21. Check of a heater of back glass
   + 14.22. Explanations to electric circuits
   + 14.23. Schemes of electric equipment of the VW Golf car since September, 1997.






14.9. Removal and installation of an additional signal of braking

GENERAL INFORMATION

The additional signal of braking is established in the top part of back glass. On the holder of bulbs 32 light-emitting diodes which cannot be replaced separately are established.

Removal

PERFORMANCE ORDER
1. Open a back door.
2. Remove an upholstery of a back door.
3. Disconnect the electric socket (1) and unscrew two screws (2) fastenings of an additional lamp of a signal of braking (3 – a cross-section spring clamp, 4 – a longitudinal spring clamp).
4. Release cross-section (3) and longitudinal (4) spring clamps and remove the holder of bulbs.

Installation

Installation is made in sequence, return to removal.