VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation



Foltsvagen Golf 4
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
+ 11. Wheels and tires
+ 12. Brake system
+ 13. Body
- 14. Electric equipment and electroschemes
   14.1. Filament lamps
   14.2. Electric chains
   + 14.3. Detection of not closed chain
   14.4. Safety locks
   + 14.5. Accumulator
   - 14.6. Generator
      14.6.1. Removal and generator installation
      14.6.2. Replacement of brushes of the generator and tension regulator
      14.6.3. Main malfunctions of the generator
   + 14.7. Starter
   14.8. Replacement of bulbs of external lighting
   14.9. Removal and installation of an additional signal of braking
   14.10. Replacement of bulbs of internal lighting
   + 14.11. Devices of external lighting
   + 14.12. Adjustment of light of headlights
   14.13. Removal and installation of a combination of devices
   14.14. Removal and installation of switches of a steering column
   14.15. Removal and installation of switches
   14.16. Removal and radio receiver installation
   14.17. Removal and installation of high-frequency loudspeakers
   14.18. Removal and installation of low-frequency loudspeakers
   14.19. Recommendations about phone installation
   14.20. Aerial
   14.21. Check of a heater of back glass
   + 14.22. Explanations to electric circuits
   + 14.23. Schemes of electric equipment of the VW Golf car since September, 1997.




14.6.1. Removal and generator installation

GENERAL INFORMATION

Generator

1–Poliklinovy belt;
2–generator;
3–tension regulator;
4–screws;
5–protective casing;
6–screws;
7–bolts 50, Nanometer;
8–bolts 50, Nanometer;
9–arm;
10-tension roller;
11-bolts, 45 Nanometers

Removal

PERFORMANCE ORDER
1. Remove a weight wire from the accumulator.
2. Weaken a tension and remove poliklinovy a belt.
3. From a reverse side of the generator disconnect thick (In +) and thin (D +) wires from generator plugs.
4. Unscrew the bolts (11), fixing the generator to an arm and remove the generator.

Installation

PERFORMANCE ORDER
1. Establish the generator on an arm and fix it bolts.
2. Check a condition of a poliklinovy belt and, if necessary, replace it.
3. Establish poliklinovy a belt and adjust its tension.
4. Connect to the wire generator.

Prevention

Thick wire (In +) screw on the generator the moment 15±1 Nanometer. If the wire is fixed unreliably, there can be following malfunctions:
      – incomplete battery charging;
      – the current for a food of consumers does not suffice;
      – in a place of connection of a wire probably sincere;
      – in connection with throws of tension failure of electronic blocks is possible.


5. Fix a blue wire (D +) to the generator the moment 3,2±0,2 Nanometer.
6. Connect a weight wire to the accumulator.