VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation



Foltsvagen Golf 4
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
+ 11. Wheels and tires
+ 12. Brake system
+ 13. Body
- 14. Electric equipment and electroschemes
   14.1. Filament lamps
   14.2. Electric chains
   + 14.3. Detection of not closed chain
   14.4. Safety locks
   + 14.5. Accumulator
   + 14.6. Generator
   - 14.7. Starter
      14.7.1. System of start of the engine
      14.7.2. Removal and installation
      14.7.3. Check, removal and installation of the traction relay of a starter
      14.7.4. Main malfunctions of a starter
   14.8. Replacement of bulbs of external lighting
   14.9. Removal and installation of an additional signal of braking
   14.10. Replacement of bulbs of internal lighting
   + 14.11. Devices of external lighting
   + 14.12. Adjustment of light of headlights
   14.13. Removal and installation of a combination of devices
   14.14. Removal and installation of switches of a steering column
   14.15. Removal and installation of switches
   14.16. Removal and radio receiver installation
   14.17. Removal and installation of high-frequency loudspeakers
   14.18. Removal and installation of low-frequency loudspeakers
   14.19. Recommendations about phone installation
   14.20. Aerial
   14.21. Check of a heater of back glass
   + 14.22. Explanations to electric circuits
   + 14.23. Schemes of electric equipment of the VW Golf car since September, 1997.










14.7.3. Check, removal and installation of the traction relay of a starter

Check and removal

PERFORMANCE ORDER
1. Remove a starter.
2. Using additional wires of big section, connect the starter case to the negative plug of the accumulator, and the positive plug of the accumulator connect to the plug 50.
3. If thus the driving gear wheel of a starter moves forward, but the engine of a starter does not rotate, means, the electric motor of a starter is faulty or contacts of the traction relay scorched.
4. If the gear wheel of a starter does not move forward, means, the traction relay failed and it is necessary to replace it.
5. Unscrew a nut and disconnect a wire going from the electric motor of a starter to the bottom contact of the traction relay.
6. Unscrew screws and remove the traction relay from a starter.

Installation

PERFORMANCE ORDER
1. Apply a thin film hermetic on the surface of the traction relay interfaced to a starter (F).
2. Hook on an anchor of the traction relay for the operating lever, then screw in screws of fastening of the traction relay to a starter.
3. Connect a wire of the electric motor of a starter to the bottom contact of the traction relay and fix it.
4. Check operation of the traction relay.
5. Establish a starter.