VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation



Foltsvagen Golf 4
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
+ 11. Wheels and tires
+ 12. Brake system
+ 13. Body
- 14. Electric equipment and electroschemes
   14.1. Filament lamps
   14.2. Electric chains
   - 14.3. Detection of not closed chain
      14.3.1. Detection of a rupture of a chain
      14.3.2. Detection of a source of short circuit
      14.3.3. Detection of bad grounding
   14.4. Safety locks
   + 14.5. Accumulator
   + 14.6. Generator
   + 14.7. Starter
   14.8. Replacement of bulbs of external lighting
   14.9. Removal and installation of an additional signal of braking
   14.10. Replacement of bulbs of internal lighting
   + 14.11. Devices of external lighting
   + 14.12. Adjustment of light of headlights
   14.13. Removal and installation of a combination of devices
   14.14. Removal and installation of switches of a steering column
   14.15. Removal and installation of switches
   14.16. Removal and radio receiver installation
   14.17. Removal and installation of high-frequency loudspeakers
   14.18. Removal and installation of low-frequency loudspeakers
   14.19. Recommendations about phone installation
   14.20. Aerial
   14.21. Check of a heater of back glass
   + 14.22. Explanations to electric circuits
   + 14.23. Schemes of electric equipment of the VW Golf car since September, 1997.







На www.3d-fotozona.ru буллет тайм эвент.
Оборудование для розлива химии узнать больше.



14.3.1. Detection of a rupture of a chain

PERFORMANCE ORDER
1. For check of integrity of a chain connect the device for verification of schemes or negative щуп the voltmeter to the negative plug of the accumulator or the earthed element.
2. Connect the second щуп to connection in a checked chain, it is desirable for the next to the accumulator or a safety lock. Thus this site of a chain should be energized from the accumulator if only the connection socket to the accumulator does not carry out a current or did not fuse a safety lock (thus do not forget that some chains of electric equipment join only at key turn in the ignition lock in a certain situation).
3. Include the chain, then connect щуп a tester to the connection closest to the switch of a chain on the party of the checked element.
4. If tension is present (about what the control bulb testifies or voltmeter indications), it means that the chain site between the corresponding connection and the switch has no gaps.

Continue chain check by the same image and after site detection on which there is no tension. It means that the rupture of a chain occurred between this point and a point of the previous check on which there was a tension. The majority of problems of the opened chain are caused by the broken or weakened socket.