VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation


Foltsvagen Golf 4
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
+ 11. Wheels and tires
+ 12. Brake system
+ 13. Body
- 14. Electric equipment and electroschemes
   14.1. Filament lamps
   14.2. Electric chains
   + 14.3. Detection of not closed chain
   14.4. Safety locks
   + 14.5. Accumulator
   + 14.6. Generator
   + 14.7. Starter
   14.8. Replacement of bulbs of external lighting
   14.9. Removal and installation of an additional signal of braking
   14.10. Replacement of bulbs of internal lighting
   + 14.11. Devices of external lighting
   - 14.12. Adjustment of light of headlights
      14.12.1. Removal and installation of the executive engine of the proof-reader of light of headlights
   14.13. Removal and installation of a combination of devices
   14.14. Removal and installation of switches of a steering column
   14.15. Removal and installation of switches
   14.16. Removal and radio receiver installation
   14.17. Removal and installation of high-frequency loudspeakers
   14.18. Removal and installation of low-frequency loudspeakers
   14.19. Recommendations about phone installation
   14.20. Aerial
   14.21. Check of a heater of back glass
   + 14.22. Explanations to electric circuits
   + 14.23. Schemes of electric equipment of the VW Golf car since September, 1997.



14.12.1. Removal and installation of the executive engine of the proof-reader of light of headlights
GENERAL INFORMATION

The executive engine of the proof-reader of light of headlights can be removed only from the headlight which has been removed from the car.

Removal

PERFORMANCE ORDER
1. Remove a headlight.
2. Uncover a lamp of a passing beam.
3. Disconnect the electric socket from the executive engine of the proof-reader of light of headlights.
4. For release from a clamp of the executive engine of the proof-reader of light of headlights on the left headlight turn it counter-clockwise.
5. For release from a clamp of the executive engine of the proof-reader of light of headlights on the right headlight turn clockwise.
6. Remove the executive engine of the proof-reader of light of headlights, thus moving aside, take a spherical head of a pusher of the proof-reader from a clip on a headlight reflector.

Installation

PERFORMANCE ORDER
1. Block a reflector from a provorachivaniye through an opening for installation of a lamp of a driving beam and insert a spherical head of a pusher of the proof-reader of light of headlights into a clip on a reflector.
2. Turn in the direction opposite to removal, and fix the executive engine of the proof-reader of light of headlights.
3. Connect the electric socket to the executive engine of the proof-reader of light of headlights.
4. Establish a cover of a lamp of a passing beam.
5. Establish a headlight.