VOLKSWAGEN GOLF IV
since 1997 of release
Repair and car operation
Foltsvagen Golf 4
+
1. Maintenance instruction
+
2. Engine
+
3. Cooling system
+
4. Fuel system
+
5. Exhaust system
+
6. Ventilation and heating system
+
7. Coupling
+
8. Transmission
+
9. Suspension brackets and power shafts
+
10. Steering
+
11. Wheels and tires
+
12. Brake system
+
13. Body
-
14. Electric equipment and electroschemes
14.1. Filament lamps
14.2. Electric chains
+
14.3. Detection of not closed chain
14.4. Safety locks
+
14.5. Accumulator
+
14.6. Generator
+
14.7. Starter
14.8. Replacement of bulbs of external lighting
14.9. Removal and installation of an additional signal of braking
14.10. Replacement of bulbs of internal lighting
-
14.11. Devices of external lighting
14.11.1. Removal and installation of headlights
14.11.2. Removal and installation of a back lamp
+
14.12. Adjustment of light of headlights
14.13. Removal and installation of a combination of devices
14.14. Removal and installation of switches of a steering column
14.15. Removal and installation of switches
14.16. Removal and radio receiver installation
14.17. Removal and installation of high-frequency loudspeakers
14.18. Removal and installation of low-frequency loudspeakers
14.19. Recommendations about phone installation
14.20. Aerial
14.21. Check of a heater of back glass
+
14.22. Explanations to electric circuits
+
14.23. Schemes of electric equipment of the VW Golf car since September, 1997.
14.11.2. Removal and installation of a back lamp
GENERAL INFORMATION
Elements of a back lamp
1–bulb of stoplights;
2–bulb of the index of turns;
3–bulb of back dimensional lighting;
4–holder of bulbs;
5–backing bulb;
6–antifog bulb;
7–nut М5, 3 Nanometers;
8–consolidation;
9–case of a back lamp
Removal
PERFORMANCE ORDER
1.
Remove the holder of bulbs of a back lamp.
2.
Unscrew three nuts (arrows) and remove a back lamp outside of the car.
Installation
PERFORMANCE ORDER
1.
Check a condition of consolidation of a back lamp and, if necessary, replace it.
2.
Establish a back lamp, thus first of all enter into an opening a lateral bolt of fastening of a lamp.
3.
Tighten nuts of fastening of a back lamp the moment of 3 Nanometers.
4.
Establish the holder of bulbs of a back lamp.
home
