Prevention
Adjustment of provision of a cover of a luggage carrier / a back door is necessary for making on the car standing on wheels.
|
|
1. Using a key on 24 mm, turn an emphasis (1) back door counter-clockwise on 90 ° and take it from a door. |
| 2. Remove the rubber buffer from a door emphasis, then, using a 3-millimetric six-sided key, unscrew the contact screw against the stop. |
|
3. Take a latch from the case on distance And = 12,5 mm. |
|
4. Establish an emphasis (1) back door at a door and, using a key on 24 mm, turn an emphasis on 90 ° clockwise. |
|
5. From two parties of the car take struts of percussion caps (1) and rasporny percussion caps (2). |
| 6. Close a back door with easy pressing in the middle of a door. |
| 7. Adjust the provision of a back door that the gap between a door and a body made 5 mm. In a specialized workshop for this purpose use the special tool 3371. |
| 8. Again open a back door. |
| 9. In this situation the back door is established on a preliminary inhaling about 3 mm. |
| 10. From two parties of the car establish in hollow percussion caps of a strut of percussion caps. |
|
11. Tighten the contact screw (1) face six-sided key the moment of 1,5 Nanometers. |
