| 1. Before assembly of a head of the block of cylinders carefully it clear. |
| 2. Grease cores of valves and their directing with pure engine oil and insert valves into a head. |
| 3. Establish the bottom plate of a klapanny spring. |
|
4. Wipe the top part of a core of the valve from engine oil. Establish the plastic plug or wrap up flutes for crackers in the top part of the valve a piece of a sticky tape for protection from damage of working edges of maslootrazhatelny caps at their installation. |
|
5. Grease with fresh engine oil a maslootrazhatelny cap and establish on directing the valve. |
|
6. Using a tubular opravka, press a maslootrazhatelny cap into place. Remove a sticky tape from a valve core. |
| 7. Establish springs and the top plate of springs. Supporting the valve in a closed position, the special adaptation compress a spring of the valve and establish crackers. Slowly remove the adaptation for compression of a spring of the valve. |
| 8. Repeat operation on the remained valves. |
| 9. In end strike on the end of each core of the valve with a plastic or copper hammer that the valve was slightly slightly opened and all elements of the valve became on the places. |
