VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation


Foltsvagen Golf 4
+ 1. Maintenance instruction
- 2. Engine
   - 2.1. Petrol engines
      2.1.1. Technical characteristics
      2.1.2. Removal and installation of the bottom mudguard of a motor compartment
      - 2.1.3. Engine 1,6-/1,8-I
         + 2.1.3.1. Power unit
         + 2.1.3.2. Gear belt
         - 2.1.3.3. Head of the block of cylinders of engines
            2.1.3.3.1. Removal
            2.1.3.3.2. Preparation of a head for installation
            2.1.3.3.3. Installation
            2.1.3.3.4. Check of hydraulic pushers of valves
            - 2.1.3.3.5. Repair of a head of the block of cylinders
               2.1.3.3.5.1. Dismantling
               2.1.3.3.5.2. Cleaning and check
               2.1.3.3.5.3. Assembly
      + 2.1.4. Engine 1,4-I
      + 2.1.5. The engine 2,3 - I-VR5
      2.1.6. Compression check in engine cylinders
      + 2.1.7. Removal and installation of a poliklinovy belt
      + 2.1.8. Recommendations about engine oils
      + 2.1.9. Circulation of engine oil
      2.1.10. Check of pressure of oil and sensor of pressure of oil
      2.1.11. Removal and installation of the oil pallet
      2.1.12. Engine start after major maintenance
      2.1.13. Diagnostics of malfunctions of the engine
      2.1.14. Main malfunctions of system of greasing
   + 2.2. Diesel engines
+ 3. Cooling system
+ 4. Fuel system
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
+ 11. Wheels and tires
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment and electroschemes





2.1.3.3.5. Repair of a head of the block of cylinders

2.1.3.3.5.1. Dismantling
PERFORMANCE ORDER
1. Remove a head of the block of cylinders.
2. Unscrew and remove inlet and final collectors.
3. Remove camshafts and hydraulic pushers.
4. Compress in the order of a spring of valves the special adaptation and take crackers of fastening of a persistent top plate of a spring.
5. Remove the top plate and valve springs.
6. Remove an internal spring of the valve.
7. Remove an external spring of the valve, paying attention not to damage a valve core.
8. Take the valve from a head of the block of cylinders from the combustion chamber.
9. Remove maslootrazhatelny caps.
10. Remove the bottom plate of a klapanny spring.
11. Place sets of details of valves in polyethylene bags and mark them for installation on the places.