VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation

Foltsvagen Golf 4
+ 1. Maintenance instruction
- 2. Engine
   - 2.1. Petrol engines
      2.1.1. Technical characteristics
      2.1.2. Removal and installation of the bottom mudguard of a motor compartment
      + 2.1.3. Engine 1,6-/1,8-I
      + 2.1.4. Engine 1,4-I
      + 2.1.5. The engine 2,3 - I-VR5
      2.1.6. Compression check in engine cylinders
      + 2.1.7. Removal and installation of a poliklinovy belt
      + 2.1.8. Recommendations about engine oils
      + 2.1.9. Circulation of engine oil
      2.1.10. Check of pressure of oil and sensor of pressure of oil
      2.1.11. Removal and installation of the oil pallet
      2.1.12. Engine start after major maintenance
      2.1.13. Diagnostics of malfunctions of the engine
      2.1.14. Main malfunctions of system of greasing
   + 2.2. Diesel engines
+ 3. Cooling system
+ 4. Fuel system
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
+ 11. Wheels and tires
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment and electroschemes

2.1.12. Engine start after major maintenance

PERFORMANCE ORDER

1. On the engine established in a motor compartment of the car, check levels of engine oil and cooling liquid.

2. Check that all earlier removed wires and hoses are established on the places.

3. Disconnect the electric socket from the fuel pump.

4. Unscrew spark plugs and disconnect the electric socket from the ignition coil. Turn the engine a starter until the control lamp of pressure of oil will not go out, then screw in spark plugs and connect electric sockets to the coil of ignition and the fuel pump.

5. Start the engine. Start of the engine can be more long, than usually because of shutdown of fuel system.

6. At operation of the engine idling check absence of leakages of the fuel, cooling liquid and oil. At this stage of operation of the engine the smell and a smoke from warm parts of the engine can be observed at burning out of the oil which has got on the engine at assembly.

7. The engine should idle until cooling liquid will not heat up that will be felt through the top hose of a radiator. Then switch off the engine. After cooling of the engine check level of oil and cooling liquid.

8. At installation in the engine of new pistons, piston rings or bearings of a cranked shaft it is necessary to make an engine running in during run of the first 800 km. Do not maintain the engine with completely open butterfly valve or under big loading at low frequency of rotation of the engine.

9. It is recommended to replace oil and the oil filter at the end of the running in period.

home