VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation



Foltsvagen Golf 4
- 1. Maintenance instruction
   + 1.1. Governing bodies, devices and equipment
   + 1.2. Weekly checks and service in a way
   - 1.3. Maintenance
      1.3.1. Technical characteristics
      1.3.2. Periodicity of service
      + 1.3.3. Maintenance regulations
      + 1.3.4. Engine oil
      + 1.3.5. Replacement of oil and oil filter
      1.3.6. Check of an exhaust system
      + 1.3.7. System of cooling of the engine
      1.3.8. Replacement of a filtering element of the air filter
      1.3.9. Check of a condition of a poliklinovy belt
      + 1.3.10. Spark plugs
      1.3.11. Replacement of the fuel filter (diesel engines)
      1.3.12. Check of tightness of hoses and liquid effluence
      1.3.13. Maple belts
      1.3.14. Measurement of wear of gear belts on diesel engines
      + 1.3.15. Box of transfers / main transfer
      + 1.3.16. Check of a forward suspension bracket and steering
      1.3.17. Shock-absorber check
      1.3.18. Radiator check
      1.3.19. Electroconducting check
      1.3.20. Check of level of liquid in the amplifier of a steering
      + 1.3.21. Brake liquid
      1.3.22. Check of forward brake shoes
      1.3.23. Check of back brake shoes of disk brakes
      1.3.24. Check of back brake shoes of drum-type brakes
      1.3.25. Check of brake hoses
      1.3.26. Check of cables of the hand brake
      1.3.27. Check of a condition of seat belts
      1.3.28. Safety cushions
      1.3.29. Hinges of doors
      1.3.30. Replacement of the dust filter
      + 1.3.31. Storage battery
      + 1.3.32. Stekloomyvateli
      1.3.33. Brushes of screen wipers
      1.3.34. Check of a starting position of the lever of a screen wiper
      1.3.35. Battery replacement in a key of remote control
      1.3.36. Service-indicator zeroing
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
+ 11. Wheels and tires
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment and electroschemes





1.3.27. Check of a condition of seat belts

GENERAL INFORMATION

Seat belt check on ruptures of threads or a razlokhmachivaniye



Prevention

It is forbidden to use a humeral belt with the electric drive from an emergency set for a seat of the child. The diagonal belt does not provide the necessary protection.


Belts, buckles and fastenings it is necessary to examine and check their serviceability periodically. If belts act in film for any reason, it is necessary to provide their correct installation.
Prevention

For no-failure operation of the mechanism of a tension observe purity of seat belts. At damage of buckles or the tension mechanism belts replace.

Belts which were exposed to strong stretching at failure, it is necessary to replace.

At influence of sunshine and chemicals the tape of a belt loses durability. At loss of initial coloring (fading) it is necessary to replace a belt.

Wash out belts only in weak soap solution. Before retraction of belts carefully them dry.

It is forbidden to process a belt band chemical compositions, to tint them or to decolour. Structures will weaken a belt. A belt decoloured or weakened by chemical compositions, it is necessary to replace.

Belts always should be changed in a set. It is forbidden to establish buckles and mechanisms of a tension of the belts, not intended for this seat, or from other cars.


PERFORMANCE ORDER
1. Be convinced that belts are not overwound as a result of their wrong installation. If belts are overwound, or jam at retraction, extend a belt for all length, sufficient in order that it could be corrected. Then return a belt in former situation.
2. Completely extend a belt and release, that it was completely involved. If the belt jams at movement in both directions, check its purity, existence on a band of dirt, greasing and other extraneous inclusions. The belt should be washed out only weak water soap solution. If the belt does not manage to be washed out this solution, it is necessary to replace it.
3. Check a condition of all places of fastening of a belt. Bolts of fastening should be reliably tightened. Remove any traces of corrosion in those places where the belt fastens to a body. The details of fastening struck with corrosion replace.
4. To replace a belt follows also at detection of the following damages:
      – ruptures of threads or a razlokhmachivaniye (see fig. Seat belt check on ruptures of threads or a razlokhmachivaniye),
      – cuts of eyelets on edges of a belt,
      – curvature of a band,
      – existence of the painted sites or cuts.
5. Assembled it is necessary to replace a belt at detection of the following damages:
      – the buckle of a belt is insufficiently reliably fixed,
      – the button of an unblocking of a belt weakened,
      – the buckle does not release a belt,
      – the effort necessary for release of a belt increased,
      – on a surface of a buckle there are cracks.