VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation


Foltsvagen Golf 4
- 1. Maintenance instruction
   + 1.1. Governing bodies, devices and equipment
   - 1.2. Weekly checks and service in a way
      1.2.1. Start from an external source (other car)
      1.2.2. If the engine is not started and the starter does not work
      1.2.3. If the engine is not started, even if the starter works normally
      1.2.4. Wheel replacement
      1.2.5. Towage
      1.2.6. Check of tightness of connections
      1.2.7. Places of weekly checks
      1.2.8. Check of level of engine oil
      1.2.9. Check of level of cooling liquid
      1.2.10. Check of brushes of a screen wiper
      1.2.11. Check of level of liquid of a stekloomyvatel
      1.2.12. Check of level of brake liquid
      1.2.13. Check of electric system
      1.2.14. Accumulator check
      1.2.15. Tires and pressure check in tires
      1.2.16. Identification data of the car
   + 1.3. Maintenance
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
+ 11. Wheels and tires
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment and electroschemes





1.2. Weekly checks and service in a way

1.2.1. Start from an external source (other car)
GENERAL INFORMATION

At start from an external source observe the following precautions.

Before connection of the external accumulator make sure that ignition is switched off.

Make sure that all electric equipment (headlights, heating devices, screen wipers etc.) are switched off.

Take into consideration all special precautions ordered on the accumulator.

Cars should not concern each other.

Make sure that the lever of gear shifting is in neutral situation (or PARK in case of an automatic transmission).

PERFORMANCE ORDER
1. Connect one end of a red wire of big section to the positive plug of the discharged accumulator.
2. Connect other end of a red wire to the positive plug of the external accumulator.
3. Connect one end of a black wire of big section to the negative plug of the external accumulator.
4. Connect other end of a black wire of big section to the power unit or an element of a body of the started car far away from the accumulator.
5. Make sure that wires do not contact with the fan, driving belts or other rotating parts of the car.
6. Start the engine, using an external source (thus the engine of the car source should idle). After start of the engine of the car with the discharged accumulator disconnect wires in return sequence.