VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation

Foltsvagen Golf 4
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Cooling system
- 4. Fuel system
   - 4.1. Cars with petrol engines
      4.1.1. Removal and installation of the fuel pump / fuel level sensor
      4.1.2. Removal and installation of the fuel filter (petrol engines)
      4.1.3. Adjustment of a cable of an accelerator
      4.1.4. Removal and installation of the case of the air filter
      4.1.5. Remote check of elements of fuel system
      + 4.1.6. Check of the fuel pump
      4.1.7. Check of the relay of the fuel pump
      + 4.1.8. Control system of the engine
   + 4.2. Cars with diesel engines
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
+ 11. Wheels and tires
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment and electroschemes

4.1.3. Adjustment of a cable of an accelerator

GENERAL INFORMATION

Cable of an accelerator of cars with petrol engines

1–accelerator cable;

2–bracket;

3–emphasis;

4–accelerator pedal;

5–remote plug;

6–plug;

7–disk;

8–restrictive screw;

9–nut, 20 Nanometers

Prevention

The cable of an accelerator is very sensitive to a peregibaniye therefore at installation it is necessary to handle with care with a cable. Even one small bend of a cable can lead to the subsequent break in use. The cables of an accelerator having excesses, it is not recommended to establish on the car.

Press an accelerator pedal against the stop and fix it in this situation or ask the assistant to hold a pedal in this situation.

Check, whether the butterfly valve lever adjoins to the limiter of full loading. Otherwise adjust an accelerator cable.

PERFORMANCE ORDER

	1. Take fixing bracket (it is specified by an arrow), a fixing cover of a cable of an accelerator to an arm.
2. Move a cover of a cable of an accelerator on an arm until the lever of a butterfly valve will not concern the limiter of the maximum loading. In this provision of a cable of an accelerator fix a cover of a cable a fixing bracket.
Models with an automatic transmission
3. Slowly press an accelerator pedal. At approach of a pedal of an accelerator to an emphasis should work the switch of compulsory inclusion of a low gear.
The engine 2,3-I with an automatic transmission
4. Disconnect the two-contact electric socket from the switch of compulsory inclusion of a low gear (kick-down) located at a forward part of a motor compartment.
	5. Connect an ohmmeter to contacts of the kick-down switch and measure resistance which should be equal to infinity.
6. Slowly press an accelerator pedal. At approach of a pedal of an accelerator to an emphasis resistance on contacts of the kick-down switch should decrease in steps to zero.
7. Otherwise make repeated adjustment of a cable of an accelerator or replace the faulty switch of compulsory inclusion of a low gear.

home