VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation


Foltsvagen Golf 4
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
+ 11. Wheels and tires
- 12. Brake system
   12.1. Technical characteristics
   + 12.2. ABS/EBV/EDS/ASR/MSR
   + 12.3. Replacement of forward brake shoes on FS-III support
   + 12.4. Replacement of brake shoes on FN-3 support
   + 12.5. Replacement of back brake shoes on disk brakes
   + 12.6. Brake disk
   12.7. Adjustment of the hand brake
   + 12.8. Replacement of back brake shoes on drum-type brakes
   12.9. Removal and installation of the back working brake cylinder
   + 12.10. Pumping of hydraulic brake system
   12.11. Brake pipelines and hoses
   12.12. Check of the vacuum amplifier of brakes
   12.13. Removal, installation and adjustment of the switch of a stoplight
   12.14. Removal and installation of cables of the hand brake
   12.15. Main malfunctions of brakes
+ 13. Body
+ 14. Electric equipment and electroschemes



12.14. Removal and installation of cables of the hand brake
GENERAL INFORMATION

Details of the lever of the hand brake
1–handle of the lever of the hand brake;
2–safety washer;
3–facing of the lever of the hand brake;
4–six-sided nut, 25 Nanometers;
5–adapter. For cars with an armrest;
6–draft;
 7–jack;
8–adjusting nut;
9–bolt;
10-cables of the hand brake;
11-switch of a control lamp of the hand brake

Removal

PERFORMANCE ORDER
1. Remove a back part of the central console.
2. Unscrew and remove the lever of the hand brake.
3. Unscrew an adjusting nut behind the lever of the hand brake so that it was possible to remove cables of the hand brake from the jack.
4. Disconnect a cable of the hand brake from the jack.
Cars with back disk brakes
5. Disconnect a cable of the hand brake from the lever of the back brake mechanism.
Cars with back drum-type brakes
6. Remove a brake drum and disconnect a cable of the hand brake from the lever of a brake shoe.
7. Lift a back part of the car and fix on supports.
8. Remove back wheels.
9. Take a cable of the hand brake from the holder on a back beam (arrow A) and from fastenings on the bottom.
10. Take a cable of the hand brake in the arrow direction from a directing pipe (1).
11. Take a cable of the hand brake from under the car.

Installation

PERFORMANCE ORDER
1. Move a cable of the hand brake into directing pipe.
Cars with back disk brakes
2. Connect a cable of the hand brake to the lever of the back brake mechanism.
Cars with drum-type back brakes
3. Connect a cable of the hand brake to the lever of a brake shoe and establish a brake drum.
4. Fix a cable of the hand brake in holders of a back beam and on the car bottom.
5. Connect a cable of the hand brake to the jack of the lever of the hand brake and screw an adjusting nut.
6. Adjust operation of the hand brake.
7. Establish a back part of the central console.