VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation


Foltsvagen Golf 4
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
+ 11. Wheels and tires
- 12. Brake system
   12.1. Technical characteristics
   + 12.2. ABS/EBV/EDS/ASR/MSR
   + 12.3. Replacement of forward brake shoes on FS-III support
   + 12.4. Replacement of brake shoes on FN-3 support
   + 12.5. Replacement of back brake shoes on disk brakes
   + 12.6. Brake disk
   12.7. Adjustment of the hand brake
   + 12.8. Replacement of back brake shoes on drum-type brakes
   12.9. Removal and installation of the back working brake cylinder
   + 12.10. Pumping of hydraulic brake system
   12.11. Brake pipelines and hoses
   12.12. Check of the vacuum amplifier of brakes
   12.13. Removal, installation and adjustment of the switch of a stoplight
   12.14. Removal and installation of cables of the hand brake
   12.15. Main malfunctions of brakes
+ 13. Body
+ 14. Electric equipment and electroschemes





12.13. Removal, installation and adjustment of the switch of a stoplight
GENERAL INFORMATION

The switch of a stoplight is fixed in an arm of a pedal of a brake. By pressing of a pedal of a brake the switch includes a braking signal in back lamps of the car. Besides, the switch of a stoplight transmits a signal about the braking beginning to the ABS/EDS control unit.

Removal

PERFORMANCE ORDER
1. Remove a covering in deepening for feet of the driver.
2. Disconnect the electric socket from the stoplight switch.
3. Turn the switch of a stoplight (1) on 90 ° counter-clockwise and take it from an arm.

Installation and adjustment

PERFORMANCE ORDER
1. Check operability of the switch of a stoplight.
2. Completely extend an operating plunzher from the case of the switch of stoplights.
3. Press a pedal of a brake and in this provision of a pedal insert the stoplight switch into an arm and turn it on 90 ° clockwise.
4. Release a brake pedal, thus there will be an automatic adjustment of the switch of stoplights.
5. Connect the electric socket to the switch of stoplights.
6. Check operation of the switch of stoplights. Even by insignificant pressing a brake pedal stoplights should light up.
7. Establish a covering in deepening for feet of the driver.