VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation


Foltsvagen Golf 4
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
- 9. Suspension brackets and power shafts
   - 9.1. Forward suspension bracket
      - 9.1.1. Amortization rack
         9.1.1.1. Removal
         9.1.1.2. Installation
      + 9.1.2. Shock-absorber and spring
      9.1.3. Removal and installation of a power shaft
      9.1.4. Replacement of protective covers of a power shaft
      9.1.5. Assembly provision of tarelchaty springs
      9.1.6. CV JOINT filling with VW-G000603 greasing
      9.1.7. Filling of external hinges with VW-G000603 greasing
      9.1.8. Filling with greasing of the internal tripoidny hinge
      9.1.9. Malfunctions of power shafts
   + 9.2. Back suspension bracket
+ 10. Steering
+ 11. Wheels and tires
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment and electroschemes



9.1.1.2. Installation
PERFORMANCE ORDER
1. Being careful, establish an amortization rack on a place and fix the top part of a rack new самоконтрящейся a nut, but at this stage do not tighten a nut finally.
2. Establish a rotary fist on the lower part of an amortization rack.
3. Insert a new bolt of fastening of the lower part of an amortization rack and screw on it a nut, having tightened it the moment of 50 Nanometers and having tightened in addition on a corner 90 °. The head of a bolt should settle down from a forward part of the car.
4. Tighten самоконтрящуюся a nut of fastening of the top part of an amortization rack the moment of 60 Nanometers thus bent by a six-sided key hold a shock-absorber rod from a provorachivaniye.
Right amortization rack
5. Connect the right power shaft to a transmission and establish the bottom mudguard of a motor compartment.
6. Fix a wire of the sensor of turns on an amortization rack.
7. Screw in a bolt of fastening of connecting bent for to the bottom lever and tighten it the moment of 45 Nanometers.
8. Establish a support on a rotary fist and fix it bolts.
9. Establish a forward wheel, then lower the car and tighten bolts of fastening of a wheel the demanded moment.
10. Establish a decorative cap of a wheel.