Foltsvagen Golf 4 + 1. Maintenance instruction + 2. Engine + 3. Cooling system + 4. Fuel system + 5. Exhaust system + 6. Ventilation and heating system + 7. Coupling - 8. Transmission + 8.1. Removal and transmission installation 8.2. Removal and installation of an automatic transmission 8.3. Gear shifting mechanism 8.4. Removal and installation of the case of the lever of gear shifting - 8.5. Adjustment of cables of gear shifting 8.5.1. Engines 1,4-/1,6-I 8.5.2. Engines 1,8-/1,9-/2,3-I 8.5.3. Adjustment check 8.6. Full automation + 8.7. Adjustment of draft of a cable of the lever of gear shifting + 9. Suspension brackets and power shafts + 10. Steering + 11. Wheels and tires + 12. Brake system + 13. Body + 14. Electric equipment and electroschemes
|
Adjustment of the mechanism of gear shifting
|
With – the screw of fastening of the adjusting adaptation;
D–screw of fixing of the lever of gear shifting;
E–fixing screw ползуна |
Before adjustment of cables of gear shifting check that a transmission, coupling and management of coupling as it should be. Besides, the lever of gear shifting should move smoothly and without breakthroughs.
PERFORMANCE ORDER |
1. Establish the gear shifting lever in neutral situation and tighten the hand brake. |
2. Release and lift up a protective cover of the lever of gear shifting. |
3. Weaken a bolt of fastening of an emphasis on a transmission (And, see fig. in subsection 8.1.1 item 4). |
|
4. Unscrew a bolt of fastening of a cable of gear shifting (A) and a nut from a tip of a cable of a preliminary choice of transfers (B) so that cable of switching could move freely in longitudinal openings. |
5. In salon of the car unscrew a bolt in a forward part of the case of the lever of gear shifting (With, see fig. Adjustment of the mechanism of gear shifting) also establish the adjusting adaptation 3422. |
6. A fixing hook of the adjusting adaptation place under a plate and fix the screw (D, see fig. Adjustment of the mechanism of gear shifting). The lever of gear shifting shift to the left in a cut ползуна the adjusting adaptation. |
7. The lever of gear shifting and the adjusting adaptation shift to the left against the stop and rigidly fix ползун the screw (Е, see fig. Adjustment of the mechanism of gear shifting). |
8. Move the gear shifting lever to the right to cuts of the adjusting adaptation and tighten a bolt (C) the moment of 15 Nanometers. |
|
9. Establish a plate with a cut and a directing pin in the switching lever on a transmission. A plate shift between the lever of gear shifting and a cover until she will rigidly not sit, but thus it should not lift the gear shifting lever. |
10. In this situation screw both cables of gear shifting, thus a cable between an emphasis and a tightening bolt it should be tense, and take a plate with a directing pin, and also the adjusting adaptation. A bolt (And, see fig. in item 4) tighten the moment of 25 Nanometers, and a nut (During) the moment of 15 Nanometers. |
11. Establish a protective cover of the lever of gear shifting. |
12. Tighten a bolt of fastening of an emphasis on a transmission the moment of 25 Nanometers. |
|
|
|