Foltsvagen Golf 4
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
- 5. Exhaust system
5.1. Catalyst
5.2. Removal and installation of an exhaust system
5.3. Alignment of an exhaust system
5.4. Replacement of the average / back exhaust silencer
5.5. Removal and installation of one exhaust silencer
5.6. Removal and installation lambda sensor
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
+ 11. Wheels and tires
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment and electroschemes
|
System of a retsirkulyatsiya of exhaust gases on models with the diesel SDI engine
1–lower part of an inlet collector;
2–consolidation. At installation it is necessary to use new consolidation;
3–valve of system of a retsirkulyatsiya; |
4–bolt, 25 Nanometers;
5–tightening bracket;
6–bolt, 10 Nanometers;
7–connecting pipe |
System of a retsirkulyatsiya of exhaust gases on cars with the diesel TDI engine
1–inlet collector;
2–sealing ring of round section. At installation it is necessary to use a new sealing ring;
3–a sucking-away branch pipe;
4–valve of system of a retsirkulyatsiya of exhaust gases; |
5–bolt, 10 Nanometers;
6–from a radiator of nadduvayemy air;
7–consolidation. At installation it is necessary to use new consolidation;
8–nut, 25 Nanometers;
9–final collector;
10-connecting pipe |
The lambda sensor serves for adjustment of composition of exhaust gases on cars with petrol engines and is screwed in in a reception exhaust pipe about the catalyst.
Removal
| PERFORMANCE ORDER |
| 1. Lift the car and fix on supports. About the catalyst remove the protective casing closing the electric socket a lambda sensor. Release from fastening brackets a wire a lambda sensor (see fig. in subsection 5.2 item 3). On all-wheel drive models and models with the engine 1,6-I with an automatic transmission a lambda sensor it is established in a final collector. On models with the engine 1,4-I a lambda sensor it is established ahead about sealing laying of a flange of a reception exhaust pipe. |
| 2. Using a wrench, unscrew a lambda sensor from a reception exhaust pipe. |
|
Installation
| PERFORMANCE ORDER |
| 1. Put on a carving a lambda sensor a thin layer of G5 greasing. |
| 2. At installation new the lambda sensor on its carving already is available greasing. Do not grease a working part a lambda sensor. |
| 3. Screw up a lambda sensor in a reception exhaust pipe and tighten it the moment of 50 Nanometers. |
| 4. Connect the electric socket to a lambda sensor and fix a wire of the electric socket. Close the electric socket a protective casing. |
| 5. Lower the car. |
|
|
|
