VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation

Foltsvagen Golf 4
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
- 5. Exhaust system
   5.1. Catalyst
   5.2. Removal and installation of an exhaust system
   5.3. Alignment of an exhaust system
   5.4. Replacement of the average / back exhaust silencer
   5.5. Removal and installation of one exhaust silencer
   5.6. Removal and installation lambda sensor
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
+ 11. Wheels and tires
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment and electroschemes

5.3. Alignment of an exhaust system

GENERAL INFORMATION

Distance x from two parties of an exhaust pipe and a cross-section beam

x – distance. It should be identical from two parties of an exhaust pipe.

After each removal or a rassoyedineniye of elements of an exhaust system it is necessary for leveling concerning a body so otherwise the system will be in a tension that will lead to emergence of cracks or additional noise.

Alignment is necessary for making on a cold exhaust system.

PERFORMANCE ORDER

1. Lift the car and fix on supports.
2. Weaken fastening of a tightening bracket between the catalyst and the average exhaust silencer.
3. Establish an exhaust pipe in such situation that it was parallel to a cross-section beam and distance x was identical from two parties of an exhaust pipe.
4. The back exhaust silencer with a back exhaust pipe arrange horizontally in relation to the earth.
Front-wheel cars
	5. Move an exhaust pipe into a tightening bracket to a label and (arrow 1).
Cars with the engine 1,6-I with a mechanical transmission
6. Move an exhaust pipe into a tightening bracket to a label s (arrow 2).
7. Tighten bolts of fastening of a tightening bracket the moment of 40 Nanometers. The tightening bracket should settle down horizontally to the left side of the car.
8. Lower the car.

home