Foltsvagen Golf 4
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
- 5. Exhaust system
5.1. Catalyst
5.2. Removal and installation of an exhaust system
5.3. Alignment of an exhaust system
5.4. Replacement of the average / back exhaust silencer
5.5. Removal and installation of one exhaust silencer
5.6. Removal and installation lambda sensor
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
+ 11. Wheels and tires
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment and electroschemes
|
Arrangement of prints on an exhaust pipe
|
|
1, 3 – prints for installation of a tightening bracket;
2–prints of a place of cutting of an exhaust pipe;
4–tightening bracket |
Removal
| PERFORMANCE ORDER |
| 1. Lift the car and fix on supports. |
| 2. The place of a rassoyedineniye of pipes is shown in drawing by prints on an exhaust pipe. The average print indicates a place of cutting of an exhaust pipe. Extreme prints serve for orientation of installation of a tightening bracket. |
| 3. In the specified place cut a pipe of an exhaust system. |
| 4. Release the exhaust silencer from rubber fastenings and take it from under the car. |
|
Installation
| PERFORMANCE ORDER |
| 1. Establish the exhaust silencer in rubber fastenings. |
| 2. For connection of pipes of an exhaust system the spare part – a tightening bracket is used. Tightening brackets are not subject to a reuse. Establish a tightening bracket on a junction of exhaust pipes so that end faces of a tightening bracket settled down near extreme prints on exhaust pipes. |
| 3. Make alignment of an exhaust system. |
| 4. Tighten bolts of fastening of a tightening bracket the moment of 40 Nanometers. |
|
|
|
