|
1. For a raising of the car it is necessary to use a jack established under basic places of a body of the car which are located approximately in 17 cm from the corresponding wheel arch. |
|
2. Establish a jack. |
Prevention
If the jack is established not under a basic place of a body, damage of a body of the car is possible. Besides, there is a danger of receiving a trauma.
The paw of a jack should cover densely a vertical edge of a longeron in order that when lifting car the jack could not slide off.
At the same time it is necessary to level the provision of a jack and to lift a jack paw until she densely will not lie down to a vertical edge.
At jack installation on soft soil, car falling from a jack is possible. Therefore it is necessary to put a jack on firm soil. If it is necessary, it is necessary to use steady and rather big support on the area.
|
| 3. For posting of the car it is necessary to use the lift. |
| 4. To avoid damages of a bottom of the car, it is necessary to use surely the corresponding linings from a prorezinenny material. |
Prevention
The car by no means cannot be lifted under the oil pallet of a case, under a transmission, under back or forward axes, differently there can be serious damages of knots and units.
|
| 5. Before entrance on the lift it is necessary to be convinced that there is a sufficient distance between low-sited points of the car and lift elements. |
|
6. In a forward part of the car a paw of the lift establish under vertical strengthenings of longerons (an arrow 1. The middle of a paw of the lift should settle down coaxially with the amplifier of the bottom bodies (arrow 2). |
|
7. In a back part of the car a paw of the lift establish under vertical strengthenings of longerons in the field of a mark 2 in a body for jack installation (arrow 1). |
