since 1997 of release

Repair and car operation

Foltsvagen Golf 4
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
- 11. Wheels and tires
   + 11.1. Instructions on operation of tires with the directed road drawing
   11.2. Gate check
   11.3. Shift of wheels
   11.4. Disks and tires
   11.5. Spare wheel
   11.6. Replacement of wheels
   11.7. Bolty-sekretki for fastening of wheels
   11.8. Antisliding chains
   11.9. Car raising
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment and electroschemes

11.5. Spare wheel


It is possible to establish a spare wheel both on a lobby, and on a back axis.

The spare wheel is intended only for short-term use and it is necessary to replace it with the usual as soon as possible.

After installation of a spare wheel pressure in its tire should make 4,2 bar.

With the established spare wheel it is impossible to exceed speed of 80 km/h. It is necessary to avoid the maximum acceleration of the car, intensive braking and sharp turns.

At installation of a spare wheel the road gleam under the corresponding axis decreases approximately by 30 mm.

It is forbidden to apply spare wheels from cars of other types.

It is not allowed to establish two or more spare wheels.