VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation


Foltsvagen Golf 4
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
+ 10. Steering
- 11. Wheels and tires
   + 11.1. Instructions on operation of tires with the directed road drawing
   11.2. Gate check
   11.3. Shift of wheels
   11.4. Disks and tires
   11.5. Spare wheel
   11.6. Replacement of wheels
   11.7. Bolty-sekretki for fastening of wheels
   11.8. Antisliding chains
   11.9. Car raising
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment and electroschemes



11.6. Replacement of wheels
GENERAL INFORMATION

The zinced wheel bolts can be applied only on steel stamped disks.

Disks from easy alloys fasten only the chromeplated wheel bolts on which there is a conic rotating washer. This washer established under a head of a bolt, protects a disk surface at a tightening of bolts.

Standard bolts of fastening of wheels have the sizes – М14х1,5х27,5. The size of a turnkey head – 17 mm.

The moment of a tightening of bolts of fastening of a wheel – 120 Nanometers.

PERFORMANCE ORDER
1. Remove a decorative cap of a wheel. For this purpose use mount and a wire bracket from a tool kit. The wire bracket is established on an opening of a cap or on an edge. Pass mount through a bracket and, having pulled mount from a wheel, remove a cap.
2. On the car standing on the earth, tighten the hand brake and weaken bolts of fastening of a wheel.
3. Lift the relevant party of the car and fix on supports.
4. Unscrew the top bolt of fastening of a wheel and on its place screw in an adjusting pin. Use of an adjusting pin facilitates installation of a spare wheel.
Prevention

Disks from easy alloys are protected from corrosion by a transparent varnish. Be careful not to damage a varnish covering. At damage of a covering cover a disk with a varnish coat.
5. For an exception of "prikipaniye" of disks of wheels to a nave before installation of a wheel apply a thin film greasings on the fillet of a nave aligning a disk of a wheel.
6. Before a vvinchivaniye do not grease a carving of bolts of fastening of a wheel.
7. A tightening of bolts of fastening of a wheel make evenly in some stages in diagonal sequence.