VOLKSWAGEN GOLF IV

since 1997 of release

Repair and car operation

Foltsvagen Golf 4
+ 1. Maintenance instruction
+ 2. Engine
+ 3. Cooling system
+ 4. Fuel system
+ 5. Exhaust system
+ 6. Ventilation and heating system
+ 7. Coupling
+ 8. Transmission
+ 9. Suspension brackets and power shafts
- 10. Steering
   10.1. Removal and safety cushion installation
   10.2. Removal and installation of a steering wheel
   10.3. Removal and installation of a tip of steering draft
   10.4. Main malfunctions of a suspension bracket and steering
+ 11. Wheels and tires
+ 12. Brake system
+ 13. Body
+ 14. Electric equipment and electroschemes

10.2. Removal and installation of a steering wheel

GENERAL INFORMATION

Steering wheel with four spokes

1–steering wheel;
2–electric socket;
3–fixing brackets. Release of a fixing bracket is made with
reverse side of a steering wheel;
4–safety cushion. The safety cushion and a steering wheel should be one type and one producer;

5–bolt, 75 Nanometers;
6–a bolt with corrugated turnkey dredging, 60 Nanometers. The bolt has a sheeting and no more than five times can be established;
7–plate;
8–returnable contact ring;
10-clamp

Elements of a steering wheel with four spokes

1–steering wheel;
2–a bolt with corrugated turnkey deepening, 60 Nanometers.
The bolt has a sheeting and can
to be used no more than five times;
3–Torx screw;
4–quencher of fluctuations. The quencher of fluctuations is established only on cars with the diesel TDI engine and an automatic transmission;

5–Torx screw, 5 Nanometers;
6–safety cushion;
7–fixing plate;
And – a label arrangement;
In – a label arrangement from a krener

Removal

PERFORMANCE ORDER

1. Remove a safety cushion from the central part of a steering wheel.

2. Establish forward wheels for movement directly forward. Thus a steering wheel should be on the average situation.

3. Unscrew the central bolt of fastening of a steering wheel and remove a steering wheel from a steering shaft.

Installation

PERFORMANCE ORDER

1. Establish a steering wheel on a shlitsa of a steering shaft so that labels on a steering wheel and steering to a shaft were combined. At installation of a steering wheel forward wheels of the car should be established in the provision of rectilinear movement, and the switch of turns should be in neutral situation.

2. Fix a steering wheel a bolt with corrugated turnkey deepening and tighten it the moment of 60 Nanometers.

3. In blow of a center punch fix a bolt of fastening of a steering wheel from unscrewing.

4. Carry out a control trip.

5. At car movement in a straight line spokes of a steering wheel should be in horizontal situation.

6. Otherwise remove a steering wheel and at installation displace it in the relevant party. Check and if necessary adjust corners of installation of wheels.

7. Check work of a sound signal and automatic return of the switch of turns to neutral situation after turn passing.

home