| 1. Before removal of a safety cushion execute the following actions. |
| 2. Switch off ignition and remove a weight wire from the accumulator. At removal of a wire of weight from the accumulator in salon of the car there should not be people. |
| 3. Isolate a wire connected to the negative plug of the accumulator to avoid casual connection of a wire. |
| 4. Disconnect the one-contact electric socket for supply voltage giving to safety cushion system. |
| 5. Establish forward wheels for movement directly forward. Thus the steering wheel should be established in average situation. |
Prevention
Non-compliance with the requirements set forth above can lead to failure of system of a safety cushion.
|
| 6. Turn a steering wheel on 90 ° counter-clockwise. |
|
7. Unblock a steering column. |
| 8. Move a steering wheel against the stop on itself and down. |
| 9. Fix the provision of a steering wheel. |
| 10. Release a safety cushion for what from a reverse side of a steering wheel insert a screw-driver edge in length of 175 mm into an opening of a steering wheel (see fig. Safety cushion release on a steering wheel with three spokes and fig. Safety cushion release on a steering wheel with four spokes). |
| 11. Moving the screw-driver handle up (shooter) (see fig. Safety cushion release on a steering wheel with three spokes and fig. Safety cushion release on a steering wheel with four spokes), an edge of a screw-driver press down a clamp 9 and release fixing clip of 3 safety cushions. |
| 12. Move a safety cushion from a steering wheel. |
| 13. Turn a steering wheel on 180 ° clockwise and similarly release a safety cushion from the second fixing clip. |
| 14. Establish a steering wheel in average situation. Thus wheels will be established for rectilinear movement. |
| 15. Disconnect the one-contact electric socket of a safety cushion. |
| 16. Remove a safety cushion. |
| 17. Do not change the provision of a steering wheel. |
